Danfoss VLT AutomationDrive FC 301 Programming Manual page 530

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Readout of the warning word corresponding to VLT 5000.
14-74 Leg. Ext. Status Word
Default value: 0
Setup: All setups
Data type: Uint32
Readout of the external status word corresponding to VLT 5000.
6.15.9 14-8* Options
14-80 Option Supplied by External 24VDC
Default value: [1] Yes
Setup:
2 setups
Data type: Uint8
To activate the parameter change, perform a power cycle.
Option Name
[0] No
[1]* Yes
14-88 Option Data Storage
Default value:
0
Setup: 2 setups
Data type:
Uint16
This parameter stores information about options over a power cycle.
14-89 Option Detection
Default value: [0] Protect option config.
Setup: 1 setup
Data type: Uint8
Selects the behavior of the drive when a change in the option configuration is detected.
530 | © 2024.09
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
NOTICE
Description
Select this option to use the 24 V DC supply of the drive.
Select this option if a 24 V DC external supply is used to power
the option. Inputs/outputs are galvanically isolated from the
drive when operated from an external supply.
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter Descriptions
Range, 0 - 4294967295
0
False
Option
–
False
Range, 0 - 65535, Array [24]
0
True
Option
–
True
AU275636650261en-003201 / 130R0334