Danfoss VLT AutomationDrive FC 301 Programming Manual page 60

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Option Name
[1891] Process PID Output
[1892] Process PID Clamped Output
[1893] Process PID Gain Scaled Output
[1899] Speed PID Torque FF. [Nm]
[2316] Maintenance Text
[3019] Wobble Delta Freq. Scaled
[3110] Bypass Status Word
[3111] Bypass Running Hours
[3401] PCD 1 Write to MCO
[3402] PCD 2 Write to MCO
[3403] PCD 3 Write to MCO
[3404] PCD 4 Write to MCO
[3405] PCD 5 Write to MCO
[3406] PCD 6 Write to MCO
[3407] PCD 7 Write to MCO
[3408] PCD 8 Write to MCO
[3409] PCD 9 Write to MCO
[3410] PCD 10 Write to MCO
[3421] PCD 1 Read from MCO
[3422] PCD 2 Read from MCO
[3423] PCD 3 Read from MCO
[3424] PCD 4 Read from MCO
[3425] PCD 5 Read from MCO
[3426] PCD 6 Read from MCO
[3427] PCD 7 Read from MCO
[3428] PCD 8 Read from MCO
[3429] PCD 9 Read from MCO
[3430] PCD 10 Read from MCO
[3440] Digital Inputs
60 | © 2024.09
Description
Shows the raw output value from the process PID controller.
Shows the output value from the process PID controller after
reaching a clamp limit.
Shows the output value from the process PID controller after
reaching a clamp limit and scaling the resulting value with
considerations to the gain.
Readout of the total commanded torque feed forward.
Showing customized messages for maintenance item and action.
View the status of the bypass as a hexidecimal value.
View the number of hours in which the motor has run in bypass
mode. The counter can be reset in parameter 15-07 Reset
Running Hours Counter. The value is saved when the drive is
turned off.
Read out the status of the digital inputs.
Parameter Descriptions
AU275636650261en-003201 / 130R0334