Danfoss VLT AutomationDrive FC 301 Programming Manual page 249

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Option Name
[222] Homing OK
[223] On target
[224] Position limit
[225] Position error
[226] Touch on target
[227] Touch activated
[228] Touch sensor found
[229] Vir. master on ref.
[231] In Power Lim. Mot.
[232] In Power Lim. Gen.
[233] In Power Limit
[234] PE power off
[246] Emcy mode was act.
[247] Emergency mode
[249] Emcy m. OPR unexpected
[250] Emcy mode limits
[254] Testing emcy mode
5-31 Terminal 29 Digital Output
Default value:
–
Setup: All setups
Data type:
Uint8
© 2024.09
Description
NOTICE
This option is only available in software version 48.XX.
NOTICE
This option is only available in software version 48.XX.
NOTICE
This option is only available in software version 48.XX.
NOTICE
This option is only available in software version 48.XX.
NOTICE
This option is only available in software version 48.XX.
NOTICE
This option is only available in software version 48.XX.
NOTICE
This option is only available in software version 48.XX.
NOTICE
This option is only available in software version 48.XX.
Parameter type:
Conversion index:
Change during operation:
AU275636650261en-003201 / 130R0334 |
Parameter Descriptions
Option
–
True
249