Danfoss VLT AutomationDrive FC 301 Programming Manual page 652

Programming Guide | VLT® AutomationDrive FC 301/FC 302
30-81 Brake Resistor (ohm)
Default value: Size related
Setup: 1 setup
Data type: Uint32
Set the brake resistor value in Ω. This value is used for monitoring the power to the brake resistor in parameter 2-13 Brake Power
Monitoring. This parameter is only active in drives with an integral dynamic brake.
30-83 Speed PID Proportional Gain
Default value:
Size related
Setup: All setups
Data type:
Uint32
Enter the speed controller proportional gain. Quick control is obtained at high amplification. However, if amplification is too great, the
process may become unstable.
30-84 Process PID Proportional Gain
Default value: Size related
Setup: All setups
Data type: Uint16
Enter the process controller proportional gain. Quick control is obtained at high amplification. However, if amplification is too great, the
process may become unstable.
30-85 Motor Frequency
Default value: Size related
Setup:
All setups
Data type: Uint32
Changing this parameter affects the settings of other parameters.
Select the motor frequency from the motor nameplate data.
Parameter 30-88 System Inertia
Default value:
Size related
Setup:
All setups
Data value: Uint32
This parameter is only available with software version 48.82 and newer.
652 | © 2024.09
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
NOTICE
Parameter type:
Conversion index:
Change during operation:
NOTICE
Parameter Descriptions
Range, 0.01 - 65535.00 ohm
-2
True
Range, 0 - 1
-4
True
Range, 0 - 10
-3
True
Range, 20.0 - 1000.0 Hz
-1
False
Range, 0.000000 - 2000.000000
2
kgm
-6
False
AU275636650261en-003201 / 130R0334