Danfoss VLT AutomationDrive FC 301 Programming Manual page 367

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Option Name
[0] Disable
[1]* Enable cyclic master
9-44 Fault Message Counter
Default value: 0
Setup: All setups
Data type:
Uint16
Indicates the number of fault events presently stored in parameter 9-45 Fault Code. The buffer capacity is maximum 8 error events. The
buffer and counter are set to 0 by reset or power-up.
9-45 Fault Code
Default value: 0
Setup: All setups
Data type: Uint16
This buffer contains the alarm word for all alarms and warnings that have occurred since the last reset or power-up. The buffer capacity is
maximum 8 error events.
9-47 Fault Number
Default value: 0
Setup: All setups
Data type: Uint16
This buffer contains the alarm word for all alarms and warnings that have occurred since the last reset or power-up. The buffer capacity is
maximum 8 error events.
9-52 Fault Situation Counter
Default value: 0
Setup: All setups
Data type: Uint16
Indicates the number of fault events that have occurred since the last reset or power-up.
9-53 PROFIBUS Warning Word
Default value:
0
Setup: All setups
Data type: V2
This parameter shows PROFIBUS communication warnings.
© 2024.09
Description
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
AU275636650261en-003201 / 130R0334 |
Parameter Descriptions
Range, 0 - 65535
0
True
Range, 0 - 0 N/A
0
True
Range, 0 - 0 N/A
0
True
Range, 0 - 1000
0
True
Range, 0 - 65535
0
True
367