Danfoss VLT AutomationDrive FC 301 Programming Manual page 738

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Parameter 1-10 Motor Construction
l
[0] Asynchron or
¢
[1] PM, non-salient SPM or
¢
[2] PM, salient IPM
¢
40-53 Current PID Anti Windup Gain
Default value: Size related
Setup: All setups
Data type: Int16
This Flux parameter is active in the drive when the following parameters are set to 1 of the values listed here:
Parameter 1-00 Configuration Mode
l
[0] Speed open loop or
l
¢
[1] Speed closed loop or
¢
[4] Torque open loop
¢
Parameter 1-01 Motor Control Principle
l
[2] Flux sensorless or
¢
[3] Flux w/motor feedback
¢
Parameter 1-10 Motor Construction
l
[0] Asynchron or
¢
[1] PM, non-salient SPM or
¢
[2] PM, salient IPM
¢
40-54 Flux /w Feedback Dynamic Mode
Default value:
[0] Off
Setup: All setups
Data type: Uint8
The position and speed controllers are executed on the fastest control task (up to 7 kHz depending on the switching frequency) in flux
with motor feedback for PM motors and on the 1 ms task for induction motors. In dynamic mode, the position and speed controllers
are also executed on the fastest control task for induction motors. This mode significantly improves control performance for induction
motors.
Option Name
[0]* Off
[1] On
40-55 Modulation Index
Default value: 100%
Setup:
All setups
Data type: Uint8
738 | © 2024.09
Paramter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Description
Dynamic mode is not activated.
Dynamic mode is activated.
Parameter type:
Conversion index:
Change during operation:
Parameter Descriptions
Range, 0 - 500%
0
True
Option
–
False
Range, 80 - 106%
0
True
AU275636650261en-003201 / 130R0334