Danfoss VLT AutomationDrive FC 301 Programming Manual page 535

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Data type: Uint8
Option Name
[0]* Do not reset
[1] Reset counter
6.16.2 15-1* Data Log Settings
The data log enables continuous logging of up to 4 data sources (parameter 15-10 Logging Sources) at individual rates (parameter 15-11
Logging Interval). A trigger event (parameter 15-12 Trigger Event) and window (parameter 15-14 Samples Before Trigger) are used to
start and stop the logging conditionally.
15-10 Logging Source
Default value: [0] None
Setup: 2 setups
Data type:
Uint16
Select the variables to be logged.
Option Name
[0]* None
[15] Readout: Actual setup
[1397] Alert alarm word
[1398] Alert warning word
[1399] Alert status word
[1472] Legacy alarm word
[1473] Legacy warning word
[1474] Leg. ext. status word
[1583] Motor Ud
[1584] Motor Uq
[1585] Motor Id
[1586] Motor Iq
[1600] Control word
[1601] Reference [Unit]
[1602] Reference %
[1603] Status word
© 2024.09
Change during operation:
Description
To reset the running hours counter to 0, select [1] Reset and
press [OK] (see parameter 15-01 Running Hours). This parameter
cannot be selected via the serial port, RS485. Select [0] Do not
reset if no reset of the running-hours counter is required.
Parameter type:
Conversion index:
Change during operation:
Description
AU275636650261en-003201 / 130R0334 |
Parameter Descriptions
True
Option, Array [4]
–
True
535