Danfoss VLT AutomationDrive FC 301 Programming Manual page 653

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Enables setting the system inertia with 6 decimals for small motors (parameter 1-69 System Inertia only has 4 decimals).
30-89 Trip Delay at Current Limit
Default value: 60.00 s
Setup: All setups
Data type: Uint16
When the output current reaches the current limit set in parameter 4-18 Current Limit, a warning is triggered. If the current limit warning
is continuously present for the time specified in this parameter, the drive trips. Enter 60 s to disable the feature.
30-9* Wifi LCP
6.24.6
Parameters for configuring the wireless LCP 103.
30-90 SSID
Default value: Size related
Setup:
1 setup
Data type: VisStr[32]
Enter the wireless network name (SSID). The default value is: Danfoss_<Serial number of the drive>. The serial number is in parameter
15-51 Frequency Converter Serial Number.
30-91 Channel
Default value:
5
Setup: 1 setup
Data type:
Uint8
Enter the wireless channel number. The default channel number is 5. Change the channel number, if there is an interference from other
wireless networks. Recommended channels: USA territory: 1, 6, 11. Europe: 1, 7, 13.
30-92 Password
Default value:
Size related
Setup: 1 setup
Data type: VisStr[48]
Enter the wireless network password. Password length: 8–48 characters.
30-93 Security Type
Default value:
[2] WPA_WPA2
Setup: 1 setup
Data type:
Uint8
Wireless network security type.
© 2024.09
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
AU275636650261en-003201 / 130R0334 |
Parameter Descriptions
Range, 0 - 60.00 s
-2
True
Range, 1 - 32
0
True
Range, 1 - 11
0
True
Range, 8 - 48
0
True
Option
–
True
653