Danfoss VLT AutomationDrive FC 301 Programming Manual page 601

Programming Guide | VLT® AutomationDrive FC 301/FC 302
18-00 Maintenance Log: Item
Default value: 0
Setup: All setups
Data type: Uint8
Shows the fault code. See the different maintenance items in parameter 23-10 Maintenance Item.
18-01 Maintenance Log: Action
Default value: 0
Setup:
All setups
Data type: Uint8
Shows the fault code. See the different maintenance actions in parameter 23-11 Maintenance Action.
18-02 Maintenance Log: Time
Default value: 0 s
Setup: All setups
Data type:
Uint32
Shows when the logged event occurred. Time is measured in s since last power-up.
18-03 Maintenance Log: Date and Time
Default value: Size related
Setup: All setups
Data type: TimeOfDay
Shows when the logged event occurred.
This requires that the date and time is programmed in parameter 0-70 Date and Time.
Date format depends on the setting in parameter 0-71 Date Format, while the time format depends on the setting in parameter 0-72
Time Format.
The drive has no back-up of the clock function. The set date/time resets to default (2000-01-01 00:00) after a power-down unless
a real-time clock module with back-up is installed. In parameter 0-79 Clock Fault, it is possible to program a warning in case the
clock has not been set properly, for example after a power-down. Incorrect setting of the clock affects the time stamps for the
maintenance events.
When mounting a VLT® Analog I/O MCB 109 option card, a battery back-up of date and time is included.
© 2024.09
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
NOTICE
NOTICE
NOTICE
Parameter Descriptions
Range, 0 - 255, Array [10]
0
False
Range, 0 - 255, Array [10]
0
False
Range, 0 - 2147483647 s, Array
[10]
0
False
Range, 0 - 0, Array [10]
0
False
AU275636650261en-003201 / 130R0334 | 601