Danfoss VLT AutomationDrive FC 301 Programming Manual page 761

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Table 57: Parameter Index
Parameter ID
45-00.0
45-00.1
45-00.2
45-00.3
6.40.2 45-1* Cockpit: Actl Status
Use the parameters in this group to compare the actual monitor values to all thresholds at the current motor output speed.
45-10 Alarm High Threshold
Default value:
0%
Setup: All setups
Data type:
Uint16
Set the maximum threshold limit. The drive triggers a notification when threshold limit is exceeded.
Table 58: Options
Parameter ID
45-10.0
45-10.1
45-10.2
45-10.3
45-10.4
45-10.5
45-11 Warning S2 High Threshold
Default value: 0%
Setup: All setups
Data type: Uint16
Set the maximum threshold limit for warning stage 2 for the index. The drive triggers a warning notification when threshold limit is
exceeded.
Table 59: Parameter Index
Parameter ID
45-11.0
45-11.1
© 2024.09
Description
Select the required option to enable stator winding monitoring.
Select the required option to enable load envelope
Select the required option to enable sensor 1 vibration.
Select the required option to enable sensor 2 vibration.
Parameter type:
Conversion index:
Change during operation:
Description
Stator Winding
Stator Winding Active
Stator Winding Load
Load Envelope
Sensor 1 Vibration
Sensor 2 Vibration
Parameter type:
Conversion index:
Change during operation:
Description
Stator Winding
Stator Winding Active
AU275636650261en-003201 / 130R0334 |
Parameter Descriptions
Range 0 - 655.35%, Array [8]
-2
True
Range, 0 - 655.35%, Array [8]
-2
True
761