Danfoss VLT AutomationDrive FC 301 Programming Manual page 555

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Setup: All setups
Data type: Uint16
View a list of all defined parameters in the drive. The list ends with 0.
15-93 Modified Parameters
Default value: 0
Setup:
All setups
Data type: Uint16
View a list of the parameters that have been changed from their default setting. The list ends with 0. Changes may not be visible until up
to 30 s after implementation.
15-94 Extended Version
Default value: Size related
Setup: All setups
Data type: VisStr[65]
View a list of SW build IDs in the drive. In a service case, Hotline can ask for SW build IDs.
15-98 Drive Identification
Default value: 0
Setup:
All setups
Data type: VisStr[40]
This parameter contains data used by the VLT® Motion Control Tool MCT 10.
15-99 Parameter Metadata
Default value: 0
Setup:
All setups
Data type: Uint16
This parameter contains data used by the VLT® Motion Control Tool MCT 10.
Parameter Group 16-** Data Readouts
6.17
16-0* General Status
6.17.1
16-00 Control Word
Default value: 0
Setup: All setups
Data type: V2
View the control word sent to the drive via the serial communication port in hex code.
© 2024.09
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
AU275636650261en-003201 / 130R0334 |
Parameter Descriptions
0
False
Range, 0 - 9999, Array [1000]
0
False
Range, 0 - 65, Array [10]
0
True
Range, 0 - 40
0
False
Range, 0 - 9999, Array [35]
0
False
Range, 0 - 65535
0
False
555