Danfoss VLT AutomationDrive FC 301 Programming Manual page 582

Programming Guide | VLT® AutomationDrive FC 301/FC 302
17-56 Encoder Sim. Resolution
Default value: [0] Disabled
Setup: All setups
Data type: Uint8
Set the resolution and activate the encoder emulation function (generation of encoder signals from the measured position from a
resolver). Use this function to transfer the speed or position information from 1 drive to another. To disable the function, select [0]
Disabled.
Option Name
[0]* Disabled
[1] 512
[2] 1024
[3] 2048
[4] 4096
[5] Enable encoder sim. adv.
17-58 Encoder Sim. Resolution Adv.
Default value: 0
Setup: 1 setup
Data type: Uint16
Set the encoder simulation resolution as a continuous value in steps of 1. This parameter is only active when [5] Enable encoder sim. adv.
is selected in parameter 17-56 Encoder Sim. Resolution.
17-59 Resolver Interface
Default value:
[0] Disabled
Setup: All setups
Data type:
Uint8
Activate the VLT® Resolver Input MCB 103 when the resolver parameters are selected. To avoid damage to resolvers, adjust parameter
17-50 Poles and parameter 17-53 Transformation Ratio before enabling this parameter.
Option Name
[0]* Disabled
[1] 512
582 | © 2024.09
Parameter type:
Conversion index:
Change during operation:
Description
Set the encoder simulation resolution via parameter 17-58
Encoder Sim. Resolution Adv.
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Description
Parameter Descriptions
Option
–
False
Range, 0 - 16384
0
False
Option
–
False
AU275636650261en-003201 / 130R0334