Danfoss VLT AutomationDrive FC 301 Programming Manual page 533

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Table 48: Possible Actions when Selected Alarms Appear
Failure Parameter
Locked rotor 1490.20
AIC earth 1490.21
fault
DC-link volt- 1490.22
age out of
range
Mains contac- 1490.23
tor fault
Not used 1490.24
Fan contactor 1490.25
Inrush fault 1490.26
Fieldbus fault 1490.27
1) X = Possible selection
2) D = Default value
3) In small and medium power drives, alarm 69, Power card temperature is only a warning.
4) Only high-power drives.
5) Warning 59 is configured in 1490.19. The current limit warning can be shown by choice. The alarm cannot be configured.
VLT® Motion Control Tool MCT 10 has the element numbers listed in the column ID. Use this table with MCT 10 to get information about
specific fault levels.
Parameter Group 15-** Drive Information
6.16
15-0* Operating Data
6.16.1
15-00 Operating Hours
Default value:
0 h
Setup: All setups
Data type:
Uint32
View for how many hours the drive has run. The value is saved when the drive is turned off.
15-01 Running Hours
Default value: 0 h
Setup: All setups
Data type:
Uint32
View how many hours the motor has run. Reset the counter in parameter 15-07 Reset Running Hours Counter. The value is saved when
the drive is turned off.
© 2024.09
(continued)
Alarm Off
99 –
407 X
404 X
300 X
x X
431 –
33 X
34 X
Warning Trip
– D
X X
X X
X X
X X
– X
X X
D –
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
AU275636650261en-003201 / 130R0334 |
Parameter Descriptions
Trip lock Trip with
delayed reset
X –
D X
D X
D X
D X
D –
D X
– –
Range, 0 - 2147483647 h
74
False
Range, 0 - 2147483647 h
74
False
533