Danfoss VLT AutomationDrive FC 301 Programming Manual page 257

Programming Guide | VLT® AutomationDrive FC 301/FC 302
Option Name
[41] Below reference, low
[42] Above ref, high
[43] Extended PID Limit
[45] Bus ctrl.
[46] Bus ctrl, 1 if timeout
[47] Bus ctrl, 0 if timeout
[50] On reference
[51] MCO controlled
[59] Remote, enable, no TW
[60] Comparator 0
[61] Comparator 1
[62] Comparator 2
[63] Comparator 3
[64] Comparator 4
[65] Comparator 5
[66] Comparator 6
[67] Comparator 7
[68] Comparator 8
[69] Comparator 9
[70] Logic rule 0
[71] Logic rule 1
© 2024.09
Description
Active when the actual speed is below speed reference setting.
Active when actual speed is above speed reference setting.
Controls digital output/relay via bus. The state of the output is
set in parameter 5-90 Digital & Relay Bus Control. The output
state is retained in the event of bus timeout.
Controls output via bus. The state of the output is set in
parameter 5-90 Digital & Relay Bus Control. If a bus timeout
occurs, the output state is set high (on).
Controls output via bus. The state of the output is set in
parameter parameter 5-90 Digital & Relay Bus Control. If a bus
timeout occurs, the output state is set low (off).
See parameter group 13-1* Comparators. If comparator 0 in SLC is
true, the output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators. If comparator 1 in SLC is
true, the output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators. If comparator 2 in SLC is
true, the output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators. If comparator 3 in SLC is
true, the output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators. If comparator 4 in SLC is
true, the output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators. If comparator 5 in SLC is
true, the output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators. If comparator 6 in SLC is
true, the output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators. If comparator 7 in SLC is
true, the output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators. If comparator 8 in SLC is
true, the output goes high. Otherwise, it is low.
See parameter group 13-1* Comparators. If comparator 9 in SLC is
true, the output goes high. Otherwise, it is low.
See parameter group 13-4* Logic Rules. If logic rule 0 in SLC is true,
the output goes high. Otherwise, it is low.
See parameter group 13-4* Logic Rules. If logic rule 1 in SLC is true,
the output goes high. Otherwise, it is low.
AU275636650261en-003201 / 130R0334 |
Parameter Descriptions
257