Ip Multicast Spoofing - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip multicast spoofing

Enables or disables IGMP spoofing on the specified VLAN or on the system if no VLAN is specified.
ip multicast [vlan vid] spoofing [{enable | disable}]
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
If the IGMP spoofing is already enabled on the system, then the VLAN configuration will override the
system's configuration.
•
IGMP spoofing refers to replacing a client's MAC and IP address with the system's MAC and IP
address when proxying aggregated IGMP group membership information.
•
You can also restore the IGMP spoofing to its default (i.e., disabled) setting on the system if no VLAN
is specified, by using only ip multicast spoofing (e.g., ip multicast spoofing).
•
You can also restore the IGMP spoofing to its default (i.e., disabled) setting on the specified VLAN, by
using only ip multicast vlan vid spoofing (e.g., ip multicast vlan 2 spoofing).
Examples
-> ip multicast spoofing enable
-> ip multicast spoofing disable
-> ip multicast spoofing
-> ip multicast vlan 2 spoofing enable
-> ip multicast vlan 2 spoofing disable
-> ip multicast vlan 2 spoofing
Release History
Release 6.1.1; command was introduced.
Release 6.3.1; no parameter added.
page 27-38
VLAN on which to apply the configuration.
Enable IGMP spoofing.
Disable IGMP spoofing.
default
disable
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide June 2012