Powering-Down The Opm; Common Procedures - Nortel DMS-100 Series Maintenance Manual

Powering-down the OPM

Perform the following steps at the MAP terminal to power-down the OPM:
1. Post the OPM.
2. Identify the unit to power down.
3. Busy the OPM unit. To busy the unit, type
4. Set the switch on the power converter to OFF to remove power from the
5. Repeat this procedure for the mate unit.
6. This procedure is complete.

Common procedures

The following sections provide common troubleshooting procedures for
loading, RTS, dial tone, and ringing generators.
CAUTION
Loss of service
Use this procedure in severe conditions like anticipated
natural disasters. This procedure causes a complete loss of
service to the subscriber.
>BSY UNIT unit_no
and press the Enter key.
where
unit_no
is the number of the to power down.
busied OPM unit. This action powers the OPM unit down.
DMS-100 Family OPM Maintenance Manual XPM14 and up
Advanced troubleshooting procedures 12-3