Nortel DMS-100 Series Maintenance Manual page 351

22 Determine if a Converter Fail LED is lit.
If Converter Fail LED is
lit
not lit
At the MAP display
23 Access the PM level of the MAP display by typing
>MAPCI;MTC;PM
and pressing the Enter key.
24 Post the OPM that is controlled by the alarm and control card as recorded in
step 5 by typing
>POST LCM
and pressing the Enter key.
where
site_name
is the name of the site where the LCM is located
frame_no
is the number of the frame where the LCM is located
lcm_no
is the number of the LCM unit associated with the faulty card
25 Return to service LCM unit 1 by typing
>RTS UNIT 1
and pressing the Enter key.
26 The next action depends on your reason for performing this procedure
If you were
directed to this procedure from a
maintenance procedure
not directed to this procedure
from a maintenance procedure
27 Return to the maintenance procedure that sent you to this procedure and
continue as directed.
28 For further assistance, contact the personnel responsible for the next level of
support.
29 You have completed this procedure.
OPM card replacement procedures
site_name frame_no lcm_no
DMS-100 Family OPM Maintenance Manual XPM14 and up
NT0X91AA
in an OPM
Do
step 28
step 23
Do
step 27
step 29
8-11
(end)