Nortel DMS-100 Series Maintenance Manual page 146

Hide thumbs Also See for DMS-100 Series:

Table of Contents

2-70 Functional overview

The CI level NAG command allows operating company personnel to display

all out-of-service nodes. The MAP response to the NAG command is like the

response that applies to the NAG400 log report. The command and log report

are part of the NAG feature. The NAG feature provides a snapshot of nodes in

the system that are out-of-service or have a REX issue. Operating company

personnel can include the offline nodes in the output. To include offline nodes,

enter the command string NAG ALL. The log report function runs each hour.

Enter the command string NAG ON or NAG OFF to turn the log report

function on or off.

The system can include a node in the output or log report. This event requires

that the node must be in SysB, CBsy, ISTb or ManB state. The system can also

include a node when the node fails, aborts or does not complete the last REX

test. When a node does not have a REX problem, the string ATP appears in the

REX column. The string ATP indicates that all tests pass.

The following output describes an abbreviated report in response to the NAG

Front End Load: FSL37AO

Offline Node count:

297-8361-550 Standard 04.02 December 2004

Troubleshooting