Nortel DMS-100 Series Maintenance Manual page 133

OFF
The OFF parameter does not allow the resumption of the office-level test. A
message appears to indicate the test is OFF. Any system BRTs in progress can
complete. OFF is the default.
When the test is disabled, the test does not begin until enabled with the ON
option. When the ON option allows the test, the office-level test resumes at the
point where the test was turned OFF. This option does not affect the operation
of the manual TST command at the LCM MAP display level.
SUPPRESS
When an LCM undergoes a system-initiated BRT, the system busies, tests and
RTSs each drawer. When these state changes occur, the system generates a
PM181 log that indicates the change. This parameter allows the user to
suppress PM181 logs for any LCM that undergoes a system BRT. The system
does not suppress the PM181 logs for an LCM that does not in a current system
BRT. The SUPPRESS command does not affect a manual BRT run on a single
drawer. The parameter can be issued at any time. A message appears that
indicates the system suppresses the logs.
ALLOW
The ALLOW parameter allows the PM181 drawer to change logs. The system
BRT causes these logs.
RESET
The RESET parameter allows the user to restart an office-level test as if the
LCMs had not been tested before. The user must turn the test OFF before use
of this parameter occurs. When the user attempts to reset the BRT when the
BRT is ON, a message appears. This message indicates the BRT must be OFF
before RESET can occur. All current tests must be complete before RESET
can occur. Use this option at any time. This option does not affect the
operation of a manual TST command at the LCM MAP display level.
QUERY
The QUERY parameter displays the following:
• the current ON/OFF status of the office-level test
• the number of LCM-level tests in progress
• the next LCM to test in the scheduled BRT in the format of HOST 00 0 0
• the status of the SUPPRESS/ALLOW commands
Test operation
The system performs BRT for each LCM. When a manual BRT occurs, the
BRT occur for each drawer. For tests that run on each LCM, the BRT occurs
on all drawers of the LCM automatically. Use the TST DRWR drwr_no
DMS-100 Family OPM Maintenance Manual ISN07 (TDM)/SN07 (DMS) and up
Functional overview 2-57