Nortel DMS-100 Series Maintenance Manual page 556

8-216 OPM card replacement procedures
NTMX45
in an OPM HIE
At the MAP terminal
4
At the RLCM frame
5
6
297-8361-550 Standard 04.01 September 2000
(continued)
Busy the inactive ESA processor by typing
>BSY
and pressing the Enter key.
Example of a MAP response:
ESA 4 This action will take this PM
out of service
Please confirm ("YES", "Y", "NO", or "N"):
Respond by typing
>YES
Put on a wrist strap.
Remove the NTMX45 card as shown in the following figures.
a Locate the damaged card on the appropriate shelf.
WARNING
Static electricity damage
Before removing any cards, put on a wrist strap and connect
it to the wrist strap grounding point on the left side of the
frame supervisory panel of the LCM. This protects the
equipment against damage caused by static electricity.
DANGER
Equipment damage
Take the following precautions when removing or inserting a
card:
1. Do not apply direct pressure to the components.
2. Do not force the cards into the slots.