Supported Subscriber Line Types - Nortel DMS-100 Series Maintenance Manual

4-18 ESA maintenance overview
Downloading the ESA processor
The system downloads translation data to the ESA processor as follows:
•
•
•

Supported subscriber line types

During OPM ESA mode, the supported subscriber line types are POTS and
MDC. The line types are listed below.
POTS line types
The supported POTS line types are as follows:
•
•
•
•
•
•
•
•
•
•
MDC lines
The supported MDC line types are as follows:
•
•
•
297-8361-550 Standard 04.02 December 2004
manually: The LOADPM command downloads data manually to the ESA
processor.
during return to service (RTS): The RTS command downloads data
automatically to the ESA processor if the ESA processor cannot perform
call processing with current data.
automatically: The system loads data during daily updates of the ESA
processor as the RLCM_ESADUPD_HOUR office parameter specifies.
1FR - single party flat rate
1MR - individual message rate. The system treats the lines the same as
single party flat rate lines.
2FR - two-parties flat rate
4FR - four-parties flat rate fully selected without ANI
8FR - eight-parties flat rate semi-selective without ANI
10FR - multi-party flat rate without ANI
CCF - coin coin first service. The system returns the coin.
CDF - coin dial tone first service. The system returns the coin. The CDF
phones cannot make 911 or 0 calls without the initial coin deposit while in
ESA mode.
CSP - coin semi-postpay service. The system does not return the coin and
coins are not required to enable a speech path.
PBX lines - PBX message rate lines are treated as PBX flat rate lines.
loop and ground start lines
500 and 2500 set
Meridian business set (MBS). The system handles the MBS as a 2500 set.
The system supports primary directory number (PDN), HOLD and
RELEASE keys.