Nortel DMS-100 Series Maintenance Manual page 482

8-142 OPM card replacement procedures
NT6X51
in an OPM
(continued)
Replacing an NT6X51 card in an OPM
Proceed only if you have been directed to this card replacement
procedure from a step in a maintenance procedure, are using the
procedure for verifying or accepting cards, or have been directed to this
procedure by your maintenance support group.
At your Current Location
1
2
At the MAP display
3
297-8361-550 Standard 04.01 September 2000
CAUTION
Loss of service
This procedure includes directions to manually busy one or
more peripheral module (PM) units. Since manually busying
a PM unit can cause service degradation, perform this
procedure only if necessary to restore out-of-service
components. Otherwise, carry out this procedure during
periods of low traffic.
Obtain a replacement card. Ensure that the replacement card has the same
product equipment code (PEC), including suffix, as the card that is to be
removed.
If you were directed to this procedure from another maintenance procedure,
go to step 6; otherwise, continue with step 3.
Access the PM level and post the LCM by typing
>MAPCI;MTC;PM;POST LCM site frame lcm
and pressing the Enter key.
where
site
is the site name of the OPM (alphanumeric)
frame
is the frame number of the OPM (0-511)
lcm
is the number of the LCM
ATTENTION