Rear Wheel Alignment - Toyota Camry Manual

A
D
Front
C
SUSPENSION AND AXLE –

REAR WHEEL ALIGNMENT

INSPECTION
1. MEASURE VEHICLE HEIGHT
Vehicle height: See page
NOTICE:
Before inspecting the wheel alignment, adjust the vehicle
height to specification.
2. INSTALL CAMBER – CASTER – KINGPIN GAUGE
ONTO VEHICLE OR POSITION VEHICLE ON WHEEL
ALIGNMENT TESTER
Follow the specific instructions on the equipment manufacturer.
3. INSPECT CAMBER
Camber
HINT:
Camber in not adjustable, it measurement is not within the
specifications, inspect the suspension parts for damaged and/
or worn–out parts and replace them as necessary.
4. INSPECT TOE–IN
B
Toe–in
(Total)
If the toe–in is not within the specification, adjust it at the No.2
lower suspension arm.
SA3213
5. ADJUST TOE–IN
(a) Measure the length of the left and right No.2 lower sus-
pension arms.
No.2 lower suspension arm length difference:
1 mm (0.04 in.) or less
If the left–right difference is larger than the specification, adjust
the length.
W03090
REAR WHEEL ALIGNMENT
5S–FE
–0°42' ± 45'
(–0.7° ± 0.75°)
Left–right error 45' (0.75°) or less
A + B: 0°24' ± 12' (0.4° ± 0.2°)
C – D: 4 ± 2 mm (0.16 ± 0.08 in.)
Author :
SA–4
1MZ–FE
–0°45' ± 45'
(–0.75° ± 0.75°)
45' (0.75°) or less
Date :
SA–7
SA07A–01
1958