Toyota Camry Manual page 2830

SR–48
SST
SST
Fulcrum
Length
STEERING
18. INSTALL RH AND LH RACK BOOTS, CLAMPS AND
CLIPS
(a) Ensure that the steering rack hole is not clogged with
grease.
HINT:
If the hole is clogged, the pressure inside the boot will change
after it is assembled and the steering wheel is turned.
R11669
(b) Install the boot.
NOTICE:
Be careful not to damage or twist the boot.
(c) Using SST, tighten the clamp as shown in the illustration.
2 mm
SST
(0.79 in.)
or less
19. INSTALL RH AND LH TIE ROD ENDS AND LOCK NUTS
(a) Screw the lock nut and tie rod end onto the rack end until
the matchmarks are aligned.
(b) After adjusting toe–in, torque the nut.
W04223
(See page SA–4)
Torque: 74 N·m (750 kgf·cm, 54 ft·lbf)
20. INSTALL 2 TURN PRESSURE TUBES
(a) Coat 2 new O–rings with power steering fluid and install
them to the tube.
(b) Using SST, install the tube.
SST
Torque: 10 N·m (102 kgf·cm, 7 ft·lbf)
HINT:
L
Use a torque wrench with a fulcrum length of 250 mm
(9.84 in.).
W04231
L
This torque value is effective in case that SST is parallel
to a torque wrench.
– POWER STEERING GEAR
09521–24010
09633–00020
Author : Date :
2143