Toyota Camry Manual page 2838

SA–6
A B
Front
A: Inside
B: Outside
SUSPENSION AND AXLE
6. ADJUST TOE–IN
(a) Remove the boot clamps.
(b) Loosen the tie rod end lock nuts.
(c) Turn the left and right rack ends an equal amount to adjust
the toe–in.
HINT:
z
Try to adjust the toe–in to the center value.
z
Make sure that the length of the left and right rack ends
is the same.
W03088
Rack end length difference:
1.5 mm (0.059 in.) or less
(d) Torque the tie rod end lock nuts.
Torque: 74 N·m (750 kgf·cm, 54 ft·lbf)
(e) Place the boot on the seat and install the clip it.
HINT:
Make sure that the boots are not twisted.
7. INSPECT WHEEL ANGLE
B A
Turn the steering wheel fully, and measure the turning angle.
195/70R14
205/65R15
If the wheel angles differ from the specification, check the left
SA0028
and right rack end length.
– FRONT WHEEL ALIGNMENT
Tire size Inside wheel
37°12' ± 2°
(37.2° ± 2°)
35°47' ± 2°
(35.78° ± 2°)
Author :
Outside wheel
<Reference>
32°21'
(32.45°)
31°25'
(31.42°)
Date :
1957