Toyota Camry Manual page 2778

ST–16
STARTING (1MZ–FE)
z
If the contact plate is not pressed down with the spe-
cified pressure, the contact plate may tilt due to coil
deformation or the tightening of the nut.
(2)
SST
SST
Torque: 17 N·m (173 kgf·cm, 13 ft·lbf)
NOTICE:
If the nut is over tightened, it may cause cracks on the in-
side of the insulator.
B01240
(h) Clean the contact surfaces of the remaining contact plate
and plunger with a dry shop rag.
(i) Reinstall the plunger, new gasket and end cover with the
3 bolts.
Torque: 2.5 N·m (26 kgf·cm, 23 in.·lbf)
B01241
– STARTER
Using SST, tighten the nuts to the specified torque.
09810–38140
Author : Date :
1743