Toyota Camry Manual page 2850

SA–18
LH
RH
SUSPENSION AND AXLE –
7. REMOVE LH DRIVE SHAFT
(a) Using a brass bar and hammer, remove the drive shaft.
HINT:
At the time of installation, please refer to the following items.
z
z
z
W03143
z
z
(b) Using a screwdriver, remove the snap ring from the in-
board joint shaft.
8. REMOVE RH DRIVE SHAFT
(a) Remove the bearing lock bolt.
Torque: 32 N·m (330 kgf·cm, 24 ft·lbf)
(b) Using pliers, remove the snap ring and drive shaft.
HINT:
At the time of installation, coat gear oil to the inboard joint shaft
and differential case sliding surface.
W03144
FRONT DRIVE SHAFT (5S–FE)
Coat gear oil to the inboard joint shaft and differen-
tial case sliding surface.
Before installing the drive shaft, set the snap ring
with its opening side facing downward.
Whether or not the inboard joint shaft is making con-
tact with the pinion shaft can be known by the sound
or feeling when driving it in.
After installation, check that there is 2 – 3 mm (0.08
– 0.12 in.) of play in the axial direction.
After installation, check that the drive shaft cannot
be removed by hand.
Author : Date :
1969