Toyota Camry Manual page 2803

5S–FE Engine :
SST
1MZ–FE Engine :
SST
Pressure
Feed Tube
Example 5S–FE Engine :
A
STEERING
REMOVAL
1.
Remove the 2 bolts.
2.
NOTICE:
Take care not to spill fluid on the drive belt.
3.
(a)
(b)
(c)
(d)
(e)
(f)
(g)
W04220
4.
Loosen the 2 (A and B) bolts.
5.
(a)
(b)
B
HINT:
Bolt A cannot be removed.
W03360
6.
(a)
NOTICE:
Be careful not to drop the switch.
If the switch is dropped or strongly damaged, replace it with a
new one.
(b)
– POWER STEERING VANE PUMP
REMOVE FRONT FENDER APRON SEAL RH
DISCONNECT RETURN HOSE
DISCONNECT PRESSURE FEED TUBE
5S–FE Engine:
Remove the clamp plate set bolt and nut.
5S–FE Engine:
Remove the 2 clamp plates and 2 holders from the tube.
5S–FE Engine:
Remove the clamp from the tube.
1MZ–FE Engine:
Remove the 2 clamp plate set nuts.
1MZ–FE Engine:
Remove the bolt.
1MZ–FE Engine:
Remove the 2 clamp plates and 2 holders from the tube.
5S–FE and 1MZ–FE Engines:
Using SST, disconnect the tube.
SST 09631–22020
REMOVE DRIVE BELT
REMOVE PS VANE PUMP ASSEMBLY WITH PRES-
SURE FEED TUBE
Disconnect the connector from the oil pressure switch.
Loosen bolt A sufficiently so that pump assembly can be
removed.
REMOVE PRESSURE FEED TUBE
Remove the oil pressure switch from the union bolt.
Remove the union bolt and gasket.
Author :
SR–21
SR06O–01
Date :
2116