Toyota Camry Manual page 2777

Long
(4)
(7) (6) (5)
(1)
Lead Terminal
Inside
40 mm
37 mm
20 mm
STARTING (1MZ–FE)
HINT:
Match the protrusion of the insulator with the indentation of the
housing.
NOTICE:
Be careful to install the terminal insulators
(inside) and wave washers in the correct direction.
(e)
Short
(2) (3)
(7)
NOTICE:
B01238
Be careful to install the terminal insulators
(inside) and wave washers in the correct direction.
(f)
(g)
Wooden Block
Contact Plate
NOTICE:
z
B01239
– STARTER
(6) Wave washer
(7) Terminal nut
Temporarily install these new terminal C kit parts:
(1) Terminal insulator (inside)
(2) Contact plate
(3) Terminal bolt
(4) O–ring
(5) Terminal insulator (outside)
(6) Wave washer
(7) Terminal nut
Temporarily tighten the terminal nuts.
Tighten terminal nuts.
(1) Put a wooden block on the contact plate and press
it down with a hand press.
Dimensions of wooden block:
20 x 37 x 40 mm (0.79 x 1.46 x 1.57 in.)
Press force:
981 N (100 kgf, 221 lbf)
Check the diameter of the hand press ram. Then cal-
culate the gauge pressure of the press when 981 N
(100 kgf, 221 lbf) of force is applied.
Gauge pressure:
2
(kgf/cm ) = Ram diameter (cm)
221 lbf
(psi) = Ram diameter (in.)
2
2
(kPa) = (kgf/cm ) x 98.1
(kPa) = (psi) x 6.9
Author :
100 kgf
2
x 3.14 (π)
2
2
x 3.14 (π)
Date :
ST–15
1742