Toyota Camry Manual page 2853

SST
1.0 mm
(0.039 in.)
(3.39 – 3.43 in.)
SUSPENSION AND AXLE
REASSEMBLY
1. INSTALL NO.2 DUST DEFLECTOR
Using SST and a press, install a new No.2 dust deflector.
SST
R15532
2. RH DRIVE SHAFT:
ASSEMBLE INBOARD JOINT SHAFT
(a) Install a new snap ring to the inboard joint shaft.
(b) Using a press, install a new bearing.
(c) Using a snap ring expander, install a new snap ring.
FA1888
(d) Using SST, an extension bar and press, install a new dust
cover.
SST
HINT:
The clearance between the dust cover and the bearing should
SST
be kept in the range shown in the illustration.
FA1971
3. INSTALL DUST COVER
z
(LH drive shaft)
Using a press, install a new dust cover.
SA1459
z
(RH drive shaft)
Using a press, install a new dust cover until the distance
from the tip of the inboard joint shaft to the dust cover falls
within the specification, as shown in the illustration.
86 – 87mm
FA1889
– FRONT DRIVE SHAFT (5S–FE)
09309–36010, 09316–20011
09506–35010
Author :
SA–21
SA08S–01
Date :
1972