ST–6
Protrusion
(1)
STARTING (1MZ–FE)
DISASSEMBLY
1.
2.
(a)
(b)
B01156
(c)
Identation
HINT:
Align the protrusion of the field frame with the groove of the
magnetic switch.
(d)
HINT:
At the time of installation, please refer to the following items.
Use a new O–ring.
B01157
3.
(a)
B01158
(b)
(4)
(3)
(2)
B01160
4.
Using a magnetic finger, remove the steel ball from the clutch
shaft hole.
B01159
–
STARTER
REMOVE DUST PROTECTOR
REMOVE FIELD FRAME AND ARMATURE
Remove the nut, and disconnect the lead wire from the
magnetic switch terminal.
Torque: 5.9 N·m (60 kgf·cm, 52 in.·lbf)
Remove the 2 through bolts.
Torque: 5.9 N·m (60 kgf·cm, 52 in.·lbf)
Pull out the field frame together with the armature.
Remove the O–ring from the field frame.
REMOVE STARTER HOUSING, CLUTCH
ASSEMBLY AND GEAR
Remove the 2 screws.
Torque: 5.9 N·m (60 kgf·cm, 52 in.·lbf)
Remove these parts from the magnetic switch:
(1)
Starter housing and clutch assembly
(2)
Return spring
(3)
Idler gear
(4)
Bearing
REMOVE STEEL BALL
Author :
ST01W–01
Date :
1733