Toyota Camry Manual page 2819

Vinyl Tape
Shop Rag
Matchmarks
Cylinder End
Wire
Stopper
SST
STEERING
12.
Press
(a)
(b)
NOTICE:
L
L
L
R11554
13.
Remove the oil seal from the control valve assembly.
14.
(a)
R11649
(b)
(c)
R11650
15.
(a)
(b)
R11651
– POWER STEERING GEAR
REMOVE CONTROL VALVE ASSEMBLY
To prevent oil seal lip damage, wind vinyl tape on the ser-
rated part of the valve shaft.
Press out the valve assembly with the oil seal.
Place a shop rag between the valve housing and the
blocks.
Be careful not to drop the valve assembly.
Be careful not to damage the oil seal lip.
REMOVE OIL SEAL
REMOVE RACK HOUSING NO.2 BRACKET AND
GROMMET
Place matchmarks on the bracket and rack housing.
Using a screwdriver, pry the clamp of the bracket.
Remove the grommet from the bracket.
REMOVE CYLINDER END STOPPER
Using SST, turn the stopper clockwise until the wire end
is visible through the service hole.
SST 09631–10021
Using SST, turn the stopper counterclockwise, and re-
move the wire.
SST 09631–10021
Author :
SR–37
Date :
2132