Toyota Camry Manual page 2829

Rack Guide
SST
Spring Cap
Lock Nut
Claw
Fulcrum Length
SST
STEERING
16.
(a)
Fulcrum
Length
(b)
SST
W03102
NOTICE:
Use SST 09922–10010 in the direction shown in the illustra-
tion.
HINT:
Use a torque wrench with a fulcrum length of 345 mm (13.58
in.).
(c)
(d)
17.
(a)
HINT:
Align the claws of the washer with the steering rack grooves.
R11667
(b)
NOTICE:
Use SST 09922–10010 in the direction shown in the illustra-
tion.
HINT:
Use a torque wrench with a fulcrum length of 345 mm (13.58
R15545
in.).
(c)
Brass Bar
NOTICE:
Avoid any impact to the rack.
R11668
– POWER STEERING GEAR
INSTALL RACK GUIDE SPRING CAP LOCK NUT
Apply sealant to 2 or 3 threads of the nut.
Sealant:
Part No.08833–00080, THREE BOND 1344,
LOCTITE 242 or equivalent
Using SST to hold the rack guide spring cap, and using
SST, torque the nut.
SST 09631–10021, 09922–10010
Torque: 50 N·m (513 kgf·cm, 37 ft·lbf)
Recheck the total preload.
Preload (turning):
0.8 – 1.4 N·m (8 – 14 kgf·cm, 6.9 – 12.2 in.·lbf)
Remove the RH and LH rack ends.
INSTALL RH AND LH CLAW WASHERS AND RACK
ENDS
Install a new claw washer, and temporarily install the rack
end.
Using a spanner (24 mm) to hold the steering rack steady,
and using SST, torque the rack end.
SST 09922–10010
Torque: 60 N·m (615 kgf·cm, 45 ft·lbf)
Using a brass bar and hammer, stake the washer.
Author :
SR–47
Date :
2142