Toyota Camry Manual page 2667

5 mm
Hexagon
Wrench
California A/T
Sound Scope
Except California A/T
Sound Scope
SFI (1MZ–FE)
FUEL CUT RPM
INSPECTION
1.
(a)
Clip
(b)
2.
Allow the engine to warm up to normal operating temperature.
S04528
3.
TOYOTA
Hand–Held Tester
(a)
(b)
S05358
4.
(a)
(b)
(c)
HINT:
Measure with the A/C OFF.
5.
6.
HINT:
For fixing the V–bank cover, push on the cover until a "click" is
felt.
B00623
– FUEL CUT RPM
REMOVE V–BANK COVER
Using a 5 mm hexagon wrench, remove the 2 cap nuts.
Disconnect the 2 clips, and remove the V–bank cover.
WARM UP ENGINE
CONNECT TOYOTA HAND–HELD TESTER OR OBDII
SCAN TOOL
Connect the TOYOTA hand–held tester or OBDII scan
tool to the DLC3.
Please refer to the TOYOTA hand–held tester or OBDII
scan tool operator's manual for further details.
INSPECT FUEL CUT OFF PRM
Increase the engine speed to at least 3,500 rpm.
Use a sound scope to check for injector operating noise.
Check that when the throttle lever is released, injector op-
eration noise stops momentarily and then resumes.
Fuel return rpm: 1,200 rpm
DISCONNECT TOYOTA HAND–HELD TESTER OR
OBDII SCAN TOOL
REINSTALL V–BANK COVER
Author :
SF–75
SF08T–03
Date :
1574