Toyota Camry Manual page 2808

SR–26
Round End
STEERING
REASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1.
2.
3.
Using a plastic hammer, tap in 2 new pins.
NOTICE:
Be careful not to damage the pins.
4.
Align the holes of the ring and 2 straight pins, and install the ring
with the inscribed mark facing outward.
5.
(a)
Inscribed Mark
(b)
R13458
6.
Install the 10 plates with the round end facing outward.
7.
Install a new gasket.
8.
Align the holes of the plate and 2 straight pins.
R01149
9.
Install the washer so that its protrusions fit into the slots in the
side plate.
10.
(a)
(b)
R11292
– POWER STEERING VANE PUMP
COAT WITH POWER STEERING FLUID
(See page SR–18)
INSTALL VANE PUMP SHAFT
INSTALL STRAIGHT PINS
INSTALL CAM RING
INSTALL VANE PUMP ROTOR
Install the rotor with the inscribed mark facing outward.
Install a new snap ring to the vane pump shaft.
INSTALL VANE PLATES
INSTALL GASKET
INSTALL SIDE PLATE
INSTALL WAVE WASHER
INSTALL REAR HOUSING
Coat 2 new O–rings with power steering fluid and install
them to the housing.
Torque the 4 bolts.
5S–FE and 1MZ–FE Engines:
Torque: 24 N·m (240 kgf·cm, 17 ft·lbf)
Author :
SR06R–01
Date :
2121