Toyota Camry Manual page 2739

RS–72
SUPPLEMENTAL RESTRAINT SYSTEM – SIDE AIRBAG SENSOR ASSEMBLY
INSTALLATION
NOTICE:
F
Never use SRS parts from another vehicle. When re-
placing parts, replace them with new ones.
F
Never reuse the side airbag sensor assembly in-
volved in a collision when the airbag has deployed.
F
Never repair a sensor in order to reuse it.
1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY
(a) Using a torx wrench, install the side airbag sensor assem-
bly with the 3 screws.
Torx wrench: T40 (Part No.09042–00020 or locally
manufactured tool)
Torque: 20 N·m (205 kgf·cm, 15 ft·lbf)
(b) Connect the side airbag sensor assembly connector.
NOTICE:
F
Connection of the connector is done after the sensor
H01339
assembly has been installed. Make sure the sensor
assembly is installed with the specified torque.
F
If the sensor assembly has been dropped, or there are
cracks, dents or other defects in the case, bracket or
connector, replace the sensor assembly with a new
one.
F
When installing the sensor assembly, take care that
the SRS wiring does not interfere with other parts and
is not pinched between other parts.
F
After installation, shake the sensor assembly to
check that there is no looseness.
2. INSTALL FRONT SEAT OUTER BELT RETRACTOR
(See page BO–134)
(a) Install the retractor with the 2 bolts.
Torque:
Upper bolt: 7.5 N·m (76 kgf·cm, 66 in.·lbf)
Lower bolt: 42 N·m (430 kgf·cm, 31 ft·lbf)
(b) Connect the pretensioner connector.
3. INSTALL CENTER PILLAR LOWER GARNISH
4. INSTALL FRONT DOOR SCUFF PLATE
H01352
Author : Date :
RS05W–02
2217