Toyota Camry Manual page 2896

SA–64
Rear
B A
SUSPENSION AND AXLE
REMOVAL
1.
2.
3.
(a)
(b)
HINT:
At the time of installtion,after stabilizing the suspension, torque
the bolts.
(c)
W03216
4.
(a)
HINT:
At the time of installtion, after stabilizing the suspension, torque
the nuts.
(b)
HINT:
W03217
At the time of installtion, face the paint mark to the rearward.
5.
6.
(a)
(b)
B
A
(c)
W03219
– REAR LOWER SUSPENSION ARM AND STRUT ROD
REMOVE REAR WHEEL
Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
REMOVE EXHAUST CENTER PIPE
5S–FE Engine: (See page EM–114)
1MZ–FE Engine: (See page EM–111)
REMOVE STRUT ROD
Remove the bolt and disconnect the parking brake cable.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
Remove the 2 bolts and nuts.
Torque: 113 N·m (1,150 kgf·cm, 83 ft·lbf)
Remove the strut rod.
REMOVE NO.2 LOWER SUSPENSION ARM
Remove the 3 nuts, suspension arm washer and wash-
ers.
Torque: 181 N·m (1,850 kgf·cm, 134 ft·lbf)
Remove the No.2 lower suspension arm.
REMOVE LEFT AND RIGHT STABILIZER BRACKETS
(See page SA–70)
REMOVE NO.1 LOWER SUSPENSION ARM
Support the suspension member with a jack.
Remove the 4 nuts, 2 bolts and suspension member low-
er stoppers.
Torque:
Bolt: 51 N·m (520 kgf·cm, 38 ft·lbf)
Nut A: 51 N·m (520 kgf·cm, 38 ft·lbf)
Nut B: 38 N·m (390 kgf·cm, 28 ft·lbf)
Lower the suspension member.
Author :
SA08H–01
Date :
2015