Toyota Camry Manual page 2772

ST–10
Ohmmeter
No Continuity
Free
Terminal C
Terminal 50
Terminal 50
STARTING (1MZ–FE)
6.
Check the brush holder insulation.
If there is continuity, repair or replace the brush holder.
7.
(a)
If damaged, replace the gear or clutch assembly.
P13481
If damaged, also check the ring gear of the flywheel/drive plate
for wear or damage.
(b)
Lock
If necessary, replace the clutch assembly.
B01162
8.
(a)
Ohmmeter
If there is no continuity, check and replace the magnetic switch.
Continuity
B01163
(b)
Ohmmeter
If there is no continuity, replace the magnetic switch.
9.
Turn the bearing by hand while applying inward force.
If resistance is felt or the bearing sticks, replace the bearing.
(See page ST–11)
Continuity
B01164
– STARTER
INSPECT BRUSH HOLDER
Using an ohmmeter, check that there is no continuity be-
tween the positive (+) and negative (–) brush holders.
INSPECT CLUTCH AND GEAR
Check the gear teeth on the pinion gear, idler gear and
clutch assembly for wear or damage.
Check the clutch pinion gear.
Hold the starter clutch and rotate the pinion gear counter-
clockwise, and check that it turns freely. Try to rotate the
pinion gear clockwise and check that it locks.
INSPECT MAGNETIC SWITCH
Check the pull–in coil for open circuit.
Using an ohmmeter, check that there is continuity be-
tween terminals 50 and C.
Check the hold–in coil for open circuit.
Using an ohmmeter, check that there is continuity be-
tween terminal 50 and the switch body.
INSPECT BEARING
Author : Date :
1737