Toyota Camry Manual page 2793

Torx Screw
Airbag Connector
Correct
Matchmarks
STEERING
REMOVAL
1.
NOTICE:
L
L
(a)
Screw Case
(b)
(c)
HINT:
Loosen the 2 screws until the groove along the screw circumfer-
ence catches on the screw case.
W03300
(d)
CAUTION:
L
L
NOTICE:
When removing the wheel pad, take care not to pull the air-
bag wire harness.
Wrong
W03301
2.
SST
(a)
(b)
(c)
(d)
W03302
– TILT STEERING COLUMN
REMOVE STEERING WHEEL PAD
If the airbag connector is disconnected with the igni-
tion switch at ON or ACC, DTCs will be recorded.
Never use airbag parts from another vehicle. When
replacing parts, replace with new ones.
Place the front wheels facing straight ahead.
Remove the 2 steering wheel lower No.2 covers.
Using a torx socket wrench, loosen the 2 torx screws.
Pull the pad out from the steering wheel and disconnect
the airbag connector.
When storing the wheel pad, keep the upper surface
of the pad facing upward.
Never disassemble the wheel pad.
REMOVE STEERING WHEEL
Disconnect the connector.
Remove the steering wheel set nut.
Place matchmarks on the steering wheel and main shaft
assembly.
Using SST, remove the wheel.
SST 09950–50012 (09951–05010, 09952–05010,
09953–05020, 09954–05020)
Author :
SR–11
SR06I–03
Date :
2106