Toyota Camry Manual page 2776

ST–14
(1)
Long
Short
(3)
(2)
Identation
STARTING (1MZ–FE)
4.
(a)
B01234
(b)
If the depth of wear is greater than the maximum, replace the
contact plate.
B01235
(c)
SST
B01236
(d)
Inside
(4) (5)
(6)
(7)
Protrusion
B06419
– STARTER
REPLACE MAGNETIC SWITCH TERMINAL KIT
PARTS
Remove the 3 bolts, end cover, gasket and the plunger.
Using vernier calipers, measure the contact plate for
depth of wear.
Maximum wear: 0.9 mm (0.035 in.)
Remove the terminal kit parts.
(1) Using SST, loosen the terminal nuts.
SST 09810–38140
(2) Terminal C:
Remove the terminal nut, wave washer, terminal in-
sulator (outside), O–ring, terminal bolt, contact
plate and terminal insulator (inside).
(3) Terminal 30:
Remove the terminal nut, wave washer, terminal in-
sulator (outside), packing, O–ring, terminal bolt,
contact plate, terminal insulator (inside).
Temporarily install these new terminal 30 kit parts:
(1) Terminal insulator (inside)
(2) Contact plate
(3) Terminal bolt
(4) O–ring
(5) Packing and terminal insulator (outside)
Install the packing to the terminal insulator, and
install them.
Author : Date :
1741