Toyota Camry Manual page 2905

Torx Screw
Airbag Connector
Correct
Matchmarks
2001 CAMRY (RM819U)
STEERING
REMOVAL
1.
NOTICE:
If the airbag connector is disconnected with the ignition
switch at ON or ACC, DTCs will be recorded.
(a)
Screw Case
(b)
(c)
HINT:
Loosen the 2 screws until the groove along the screw circumfer-
ence catches on the screw case.
F00879
(d)
CAUTION:
S
S
NOTICE:
When removing the wheel pad, take care not to pull the air-
bag wire harness.
Wrong
F00878
2.
SST
(a)
(b)
(c)
(d)
W03302
– TILT STEERING COLUMN
REMOVE STEERING WHEEL PAD
Place the front wheels facing straight ahead.
Remove the 2 steering wheel lower No.2 and No.3 cov-
ers.
Using a torx socket wrench, loosen the 2 torx screws.
Pull the pad out from the steering wheel and disconnect
the airbag connector.
When storing the wheel pad, keep the upper surface
of the pad facing upward.
Never disassemble the wheel pad.
REMOVE STEERING WHEEL
Disconnect the connector.
Remove the steering wheel set nut.
Place matchmarks on the steering wheel and main shaft
assembly.
Using SST, remove the wheel.
SST 09950–50012 (09951–05010, 09952–05010,
09953–05020, 09954–05020)
Author :
SR–11
SR06I–05
Date :
2096