Toyota Camry Manual page 2831

SST
Fulcrum
Length
STEERING – POWER STEERING GEAR
INSTALLATION
1. INSTALL PS GEAR ASSEMBLY
(a) Install the gear assembly from the LH of the vehicle.
NOTICE:
Do not damage the turn pressure tubes.
(b) Torque the 2 gear assembly set bolts and nuts.
Torque: 181 N·m (1,850 kgf·cm, 134 ft·lbf)
HINT:
Lift up the stabilizer bar and install the bolts.
2. INSTALL NO.1 FUEL TUBE PROTECTOR
Install the 2 bolts and nut.
3. CONNECT STABILIZER BAR
Torque the 4 bolts.
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
4. CONNECT PRESSURE FEED AND RETURN TUBES
Using SST, connect the tube.
SST 09631–22020
Torque: 32 N·m (326 kgf·cm, 24 ft·lbf)
HINT:
L
Use a torque wrench with a fulcrum length of 300 mm
(11.81 in.).
L
This torque value is effective in case that SST is parallel
to a torque wrench.
W04224
5. CONNECT CLAMP PLATE
Torque the nut.
Torque: 10 N·m (100 kgf·cm, 7 ft·lbf)
6. CONNECT INTERMEDIATE SHAFT ASSEMBLY
(See page SR–16)
7. CONNECT RH AND LH TIE ROD ENDS
(See page SA–10)
8. POSITION FRONT WHEELS FACING STRAIGHT
AHEAD
HINT:
Do it with the front of the vehicle jacked up.
9. CENTER SPIRAL CABLE
(See page SR–16)
10. INSTALL STEERING WHEEL
(a) Install the wheel at straight–ahead position.
(b) Temporarily tighten the wheel set nut.
(c) Connect the connector.
11. BLEED POWER STEERING SYSTEM
(See page SR–4)
12. CHECK STEERING WHEEL CENTER POINT
Author : Date :
SR–49
SR06Y–01
2144