Toyota Camry Manual page 2729

RS–62
SUPPLEMENTAL RESTRAINT SYSTEM
LH side:
RH side:
H02267
H02268
– AIRBAG SENSOR ASSEMBLY
INSTALLATION
NOTICE:
F
Never use SRS parts from another vehicle. When re-
placing parts, replace them with new parts.
F
Never reuse the airbag sensor assembly involved in
a collision when the airbag has deployed.
F
Never repair a sensor in order to reuse it.
INSTALL AIRBAG SENSOR ASSEMBLY
(a) Using a torx wrench, install the airbag sensor assembly
with 4 screws.
Torx wrench: T40 (Part No.09042–00020 or locally
manufactured tool)
Torque: 20 N·m (205 kgf·cm, 15 ft·lbf)
(b) Connect the airbag sensor connectors.
NOTICE:
F
Connection of the connector is done after the sensor
assembly has been installed.
F
Make sure the sensor assembly is installed with the
specified torque.
F
If the sensor assembly has been dropped, or there are
cracks, dents or other defects in the case, bracket or
connector, replace the sensor assembly with a new
one.
F
When installing the sensor assembly, take care that
the SRS wiring does not interfere with other parts and
is not pinched between other parts.
H08322
F
After installing , shake the sensor assembly to check
that there is no looseness.
Author : Date :
RS0EZ–01
2207