Toyota Camry Manual page 2826

SR–44
SST
Cylinder End
Stopper
SST
STEERING
5.
(a)
Wire
(b)
(c)
R11656
6.
(a)
(b)
(c)
If there is change in the vacuum, check the installation of the oil
seals.
R00662
7.
(a)
HINT:
Align the projection of the grommet with the hole of the bracket.
(b)
R11657
(c)
R11658
8.
(a)
Vinyl Tape
(b)
(c)
NOTICE:
Be careful not to damage the teflon rings and oil seal.
R11575
– POWER STEERING GEAR
INSTALL CYLINDER END STOPPER
Align the installation hole for the wire of the stopper with
the slot of the rack housing.
Install a new wire into the stopper.
Using SST, turn the stopper clockwise 450 ± 50°.
SST 09631–10021
AIR TIGHTNESS TEST
Install SST to the rack housing.
SST 09631–12071
Apply 53 kPa (400 mmHg, 15.75 in.Hg) of vacuum for
about 30 seconds.
Check that there is no change in the vacuum.
INSTALL RACK HOUSING NO.2 BRACKET AND
GROMMET
Install the grommet to the bracket.
Align the matchmarks on the bracket and rack housing.
Place the bracket in a vise and tighten the vise to fasten
the clamp.
INSTALL CONTROL VALVE ASSEMBLY
To prevent oil seal lip damage, wind vinyl tape on the ser-
rated part of the valve shaft.
Coat the teflon rings with power steering fluid.
Install the valve assembly into the valve housing.
Author : Date :
2139