Toyota Camry Manual page 1426

7. HYDRAULIC TEST
Measure the line pressure.
NOTICE:
Do the test at normal operation fluid temperature 50 – 80 °C (122 – 176 °F).
D
D
The line pressure test should always be carried out in pairs. One technician should observe
the conditions of wheels or wheel stoppers outside the vehicle while the other is doing the test.
D
Be careful to prevent SST's hose from interfering with the exhaust pipe.
(1) Warm up the ATF.
(2) Remove the test plug on the transaxle case front left side and connect SST.
(See page AX–17 for the location to connect SST)
SST 09992–00095 (09992–00231, 09992–00271)
(3) Fully apply the parking brake and chock the 4 wheels.
(4) Connect an OBD II scan tool or TOYOTA hand–held tester to DLC3.
(5) Start the engine and check idling speed.
(6) Keep your left foot pressing firmly on the brake pedal and shift into D position.
(7) Measure the line pressure when the engine is idling.
(8) Depress the accelerator pedal all the way down. Quickly read the highest line pressure when
engine speed reaches stall speed.
(9) In the same manner, do the test in R position.
Specified line pressure:
Condition
Idling
Stall
If the measured pressure is not up to the specified value, recheck the throttle cable adjustment and retest.
Evaluation
If the measured values at all positions are higher
If the measured values at all positions are lower
If pressure is low in the D position only
If pressure is low in the R position only
DIAGNOSTICS
D position
362 – 422 (3.7 – 4.3, 53 – 61)
735 – 862 (7.5 – 8.8, 107 – 125)
Problem
– AUTOMATIC TRANSAXLE (A140E)
2
kPa (kgf/cm , psi)
D Throttle cable out of adjustment
D Throttle valve defective
D Regulator valve defective
D Throttle cable out of adjustment
D Throttle valve defective
D Regulator valve defective
D Oil pump defective
D O/D direct clutch defective
D D position circuit fluid leakage
D Forward clutch defective
D R position circuit fluid leakage
D Direct clutch defective
D 1st & reverse brake defective
Author :
R position kPa (kgf/cm
618 – 794 (6.3 – 8.1, 90 – 115)
1,373 – 1,608 (14.0 – 16.4, 199 – 233)
Possible cause
Date :
DI–399
2
, psi)
634