13) Assemble holders.
(1) Install oil seal into right and left holders.
ST 498447100 AXLE SHAFT OIL SEAL
INSTALLER
(2) Install bearing race into right and left hold-
ers.
ST 398477702 BEARING OUTER RACE
DRIFT
(3) Install the differential case assembly into
differential carrier in the reverse order of disas-
sembly.
14) Perform adjustment of backlash of pinion
crown gear set and adjustment of preload of differ-
ential side bearing.
REAR DIFFERENTIAL FOR VA-TYPE
S3M0522A
G3M0093
G3M0065
DI-53
(1) Turn drive pinion with ST for better fitting of
differential side bearing.
ST 498427200 FLANGE WRENCH
(2) Screw in side (left-side) holder until light
contact is made with ST.
ST 399780111 WRENCH
(3) Back off side (left-side) holder approxi-
mately 1 1/2 teeth of holder, and tighten left-side
holder by approximately 2 teeth (approximately
1 1/2 + 1/2 teeth).
[Back off amount of side (left-side) holder + 1/2
tooth.]
This + 1/2 tooth gives preload.
(4) Temporarily tighten lock plate.
NOTE:
Turn over lock plate to displace holder 1/2 tooth.
Differentials
G3M0094
G3M0064
G3M0063