Subaru Legacy 2002 Service Manual page 2273

Hide thumbs Also See for Legacy 2002:
Table of Contents

Advertisement

Power Assisted System (Power Steering)
(2) Leakage from "f"
There are two possible causes. Take following
step first. Remove the pipe assembly B from the
valve housing, and close the circuit with ST.
ST 926420000 PLUG
Turn the steering wheel from lock to lock 30 to
40 times with the engine running, then make
comparison of the leaked portion between
immediately after and several hours after this
operation.
CAUTION:
¼ If leakage from "f" is noted again:
The oil seal of pinion and valve assembly is
damaged. Replace pinion and valve assembly
with a new one. Or replace the oil seal and the
parts that are damaged during disassembly
with new ones.
¼ If oil stops leaking from "f":
The oil seal of rack housing is damaged.
Replace the oil seal and the parts that are dam-
aged during disassembly with new ones.
F: ADJUSTMENT
1) Adjust front toe.
Standard of front toe:
IN 3 — OUT 3 mm (IN 0.12 — OUT 0.12
in)
2) Adjust steering angle of wheels.
Standard of steering angle:
Except OUTBACK
Model
15 inch
wheel
Inner
37.5°±1.5°
wheel
Outer
32.6°±1.5°
wheel
STEERING GEARBOX [RHD MODEL]
S601276A01
G4M0133
OUT-
BACK
16 inch wheel
36.3°±1.5°
34.5°±1.5°
31.6°±1.5°
30.3°±1.5°
3) If steering wheel spokes are not horizontal
when wheels are set in the straight ahead position,
and error is more than 5° on the periphery of steer-
ing wheel, correctly re-install the steering wheel.
4) If steering wheel spokes are not horizontal with
vehicle set in the straight ahead position after this
adjustment, correct it by turning the right and left
tie-rods in the same direction by the same amount.
PS-64
S4M0188A
G4M0135

Advertisement

Table of Contents
loading

Table of Contents