Subaru Legacy 2002 Service Manual page 1686

6) Tighten 17 bolts with bracket, clip, etc. as
shown in the figure.
NOTE:
¼ Insert bolts from the bottom and tighten nuts at
the top.
¼ Put cases together so that drive pinion shim and
input shaft holder shim are not caught up in
between.
¼ Confirm that speedometer gear is meshed.
Tightening torque:
8 mm bolt
25 N·m (2.5 kgf-m, 18.1 ft-lb)
# 10 mm bolt
39 N·m (4.0 kgf-m, 28.9 ft-lb)
7) Tighten ball bearing attachment bolts.
Tightening torque:
29 N·m (3.0 kgf-m, 21.7 ft-lb)
TRANSMISSION CASE
8) Tighten input shaft holder attaching bolts.
Tightening torque:
(A)
(B)
9) Backlash adjustment of hypoid gear and pre-
load adjustment of roller bearing
NOTE:
Support drive pinion assembly with ST.
ST 498427100 STOPPER
S3M0161A
10) Place the transmission with case left side fac-
ing downward and put ST1 on bearing cup.
S3M0099
MT-61
Manual Transmission and Differential
20 N·m (2.0 kgf-m, 14.5 ft-lb)
Input shaft holder
Input shaft
B3M2175A
B3M1362A