Subaru Select Monitor - Subaru Legacy 2002 Service Manual

6. Subaru Select Monitor

A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
S004503A1601
1) Prepare Subaru Select Monitor kit.
<Ref. to AT-7, PREPARATION TOOL, General
Description.>
2) Connect diagnosis cable to Subaru Select
Monitor.
3) Insert cartridge into Subaru Select Monitor.
4) Connect Subaru Select Monitor to data link
connector.
(1) Data link connector located in the lower por-
tion of the instrument panel (on the driver's
side).
(A) Data link connector
(2) Connect diagnosis cable to data link con-
nector.
SUBARU SELECT MONITOR
S004503
S004503A16
S2M0285
S2M0286
B2M2960F
NOTE:
Do not connect scan tools except for Subaru
Select Monitor and OBD-II general scan tool.
5) Turn ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(A) Power switch
6) On the Main Menu
the {Each System Check} and press the [YES] key.
7) On the System Selection Menu
screen, select the {Transmission Control System}
and press the [YES] key.
8) Press the [YES] key after displayed the infor-
mation of transmission type.
9) On the Transmission Diagnosis
screen, select the {Diagnostic Code(s) Display}
and press the [YES] key.
10) On the Diagnostic Code(s) Display
screen, select the {Latest Diagnostic Code(s)} or
{Memorized Diagnostic Code(s)} and press the
[YES] key.
NOTE:
¼ For detailed operation procedure, refer to the
SUBARU SELECT
MANUAL.
¼ For detailed concerning diagnostic trouble
codes, refer to the DIAGNOSTIC TROUBLE
CODE LIST. <Ref. to AT-26, List of Diagnostic
Trouble Code (DTC).>
2. READ CURRENT DATA
1) On the Main Menu
the {Each System Check} and press the [YES] key.
2) On the System Selection Menu
screen, select the {Transmission Control System}
and press the [YES] key.
3) Press the [YES] key after displayed the infor-
mation of transmission type.
4) On the Transmission Diagnosis
screen, select the {Current Data Display & Save}
and press the [YES] key.
5) On the Data Display Menu
select the {Data Display} and press the [YES] key.
6) Using the scroll key, move the display screen
up or down until the desired data is shown.
AT-19
Automatic Transmission (Diagnostics)
display screen, select
MONITOR OPERATION
S004503A1602
display screen, select
display screen,
S2M0288C
display
display
display
display
display