Subaru Legacy 2002 Service Manual page 2002

4) Install the selected pinion height adjusting shim
on drive pinion, and press the rear bearing cone
into position with ST.
ST 398177700 INSTALLER
5) Insert drive pinion into differential carrier, install
the previously selected bearing preload adjusting
spacer and washer.
(A) Drive pinion
(B) Bearing adjusting spacer
(C) Washer
(D) Differential carrier
6) Press-fit front bearing cone into case with ST1,
ST2 and ST3.
ST1 398507703 DUMMY COLLAR
ST2 399780104 WEIGHT
ST3 899580100 INSTALLER
REAR DIFFERENTIAL FOR T-TYPE
S3M0519A
B3M0560B
G3M0085
DI-33
7) Insert spacer, then press-fit pilot bearing with
ST1 and ST2.
ST1 399780104 WEIGHT
ST2 899580100 INSTALLER
8) Fit a new oil seal with ST.
NOTE:
¼ Press-fit until end of oil seal is 1 mm (0.04 in)
inward from end of carrier.
¼ Apply grease between the oil seal lips.
ST 498447120 OIL SEAL INSTALLER
9) Press-fit companion flange with ST1 and ST2.
NOTE:
Be careful not to damage bearing.
ST1 899874100 INSTALLER
ST2 399780104 WEIGHT
Differentials
S3M0520A
G3M0087
S3M0521A